Tip – MGB Engine Mounting Tightening Tip

Following on from a recent post about MGB round rubber bumper engine mountings is a couple of suggestions:-

  1. The use of bluetac or similar to hold a nut onto a spanner to be able to position it onto an awkward stud or bolt – especially the MGB engine mountings.
  2. To get a spanner that fits the nut for the hidden engine mountings and cut it in half with an angle grinder so you can get a decent swing on it and still tighten it enough to hold tight.

Whoever designed these brackets certainly did not have the diy maintainer in mind!!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s